Bulb - Headlamp - Domestic

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION:

Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

Fig 1: Identifying Headlamp Bulb (Domestic)

Courtesy of CHRYSLER GROUP, LLC

Align the headlamp bulb base (2) with the keyed opening on the back of the headlamp unit (1).
Insert the bulb and base into the headlamp until the base is firmly seated.
Using the tabs on each side of the connector receptacle, rotate the bulb base clockwise about 30 degrees to lock it into place.
Reinstall the headlamp unit (1) into the mounting collar (3). Refer to UNIT, HEADLAMP, INSTALLATION .
Reconnect the battery negative cable.