LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Lamps/Lighting - Exterior (Service Information)) >> Switch, Stop Lamp >> Adjustments >> Adjustment

Switch, Stop Lamp: Adjustments: Adjustment

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Disconnect and isolate the battery negative cable.
  2. Remove the steering column opening cover from the instrument panel. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  3. Depress and hold the brake pedal in the depressed position.
  4. Pull the brake lamp switch plunger all the way out of the switch housing to its fully extended position.
  5. Release the brake pedal. The pedal will set the plunger to the correct position as the pedal pushes the plunger into the switch housing. The switch plunger will make a light audible ratcheting noise as it self-adjusts.
  6. Reinstall the steering column opening cover onto the instrument panel. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals