Lamp, UNDERHOOD: Removal: Lamp
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Disconnect the headlamp and dash wire harness connector (4) from the underhood lamp (3) connector receptacle.
- Remove the bulb from the underhood lamp. Refer to LAMP, UNDERHOOD, REMOVAL .
- Remove the push pin type blind rivet (2) from within the lamp housing that secures the underhood lamp mounting bracket to the inner hood panel reinforcement (1).
- Remove the underhood lamp and bracket from the inner hood panel as a unit.