Lamp, Park And Turn Signal: Removal: Lamp
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Reach behind the lower outboard corner of the grille panel (1) to access and release the two integral park/turn signal lamp (2) latch features (3) and push the lamp out through the face of the grille panel.
- From the face of the grille panel, pull the lamp out far enough to access and disconnect the wire harness connector from the bulb socket connector receptacle (4) on the back of the lamp.
- Remove the lamp from the vehicle.