Lamp, Park And Turn Signal: Installation: Lamp
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Position the park/turn signal lamp (2) to the seat in the face of the grille panel (1).
- Reconnect the wire harness connector to the lamp bulb socket connector receptacle (4).
- Be certain that the two integral latch features (3) on the back of the lamp housing are aligned with the slots in the seat.
- Push the lamp into the seat until the two latches are fully engaged in the slots.
- Reconnect the battery negative cable.