Lamp, Fog, Rear: Removal: Lamp
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following procedure applies only to vehicles manufactured for export markets. Rear fog lamps are not available in vehicles manufactured for domestic markets.
- Disconnect and isolate the battery negative cable.
- Raise and support the vehicle.
- From behind the outboard end of the rear bumper (1) disconnect the take out and connector (4) of the rear bumper wire harness from the rear fog lamp bulb socket.
- Remove the two nuts (2) that secure the two mounting studs on the lamp housing to the retainer cap (3) on the back of the rear bumper cover.
- Remove the lamp from the face of the rear bumper cover.