Lamp, Fog, Front: Removal: Bulb
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
- Disconnect and isolate the battery negative cable.
- For export market vehicles, turn the front wheels fully in either direction.
- Raise and support the vehicle.
- For domestic market vehicles equipped with the optional electronic sway bar disconnect feature, service of the right fog lamp bulb will also require removal of the front bumper lower air dam from the vehicle.
- From behind the front bumper, disconnect the engine compartment wire harness connector from the front fog lamp bulb connector receptacle (1).
- Firmly grasp the bulb by the two latch features (2) and squeeze them together to unlock the bulb from the back of the front fog lamp housing (3).
- Pull the bulb straight out from the keyed opening in the housing.