Rear Fog Lamps

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The rear fog lamp switch is integral to the left multi-function switch/SCM, which communicates with the EMIC/CCN over the LIN data bus. Before performing any of the following tests, determine whether the other functions of the left multi-function switch/SCM are operational. If the other left multi-function switch/SCM functions are ineffective, diagnose and repair that problem before attempting to repair the Rear Fog Lamps.

CONDITION	POSSIBLE CAUSES	CORRECTION
REAR FOG LAMP DOES NOT ILLUMINATE	1. Ineffective or missing bulb.	1. Test and replace rear fog lamp bulb if required.
	2. Ineffective ground circuit.	2. Test and repair open rear fog lamp ground circuit if required.
	3. Ineffective feed circuit.	3. Test and repair open fog lamp relay control rear circuit if required.
	4. Ineffective EMIC (CCN) inputs or outputs.	4. Use a diagnostic scan tool to test the EMIC (CCN) inputs and outputs. Refer to the appropriate diagnostic information.
	5. Incorrect TIPM configuration.	5. Use a diagnostic scan tool to check and correct the TIPM configuration settings if required. Refer to the appropriate diagnostic information.
	6. Ineffective TIPM inputs or outputs.	6. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information.
REAR FOG LAMP DOES NOT EXTINGUISH	1. Ineffective feed circuit.	1. Test and repair shorted fog lamp relay control rear circuit if required.
	2. Ineffective EMIC (CCN) inputs or outputs.	2. Use a diagnostic scan tool to test the EMIC (CCN) inputs and outputs. Refer to the appropriate diagnostic information.
	3. Ineffective TIPM inputs or outputs.	3. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information.