Hazard Warning Lamps
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The hazard switch is integral to the instrument panel switch bank, which communicates with the EMIC/CCN over the LIN data bus. Before performing any of the following tests, confirm whether the left and right turn signals operate satisfactorily. Then determine whether the other functions of the instrument panel switch bank are operational. If the turn signals are ineffective or operate improperly, or if the other instrument panel switch bank functions are ineffective, diagnose and repair those problems before attempting to repair the Hazard Warning Lamps.
| CONDITION | POSSIBLE CAUSES | CORRECTION |
|---|---|---|
| HAZARD WARNING LAMPS DO NOT FLASH | 1. Ineffective EMIC (CCN) inputs or outputs. | 1. Use a diagnostic scan tool to test the EMIC (CCN) inputs and outputs. Refer to the appropriate diagnostic information. |
| 2. Ineffective TIPM inputs or outputs. | 2. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information. | |
| HAZARD WARNING LAMPS DO NOT STOP FLASHING | 1. Ineffective EMIC (CCN) inputs or outputs. | 1. Use a diagnostic scan tool to test the EMIC (CCN) inputs and outputs. Refer to the appropriate diagnostic information. |
| 2. Ineffective TIPM inputs or outputs. | 2. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information. |