LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Lamps/Lighting - Exterior (Service Information)) >> Diagnosis And Testing >> Diagnosis And Testing - Lamps/Lighting - Exterior >> Daytime Running Lamps

Daytime Running Lamps

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Before performing the following tests, determine whether the headlamp low and high beams operate. If the headlamp low and high beams are also ineffective, diagnose and repair that problem before attempting to repair the Daytime Running Lamps.

CONDITION POSSIBLE CAUSES CORRECTION
DAYTIME RUNNING LAMPS WILL NOT ILLUMINATE 1. Incorrect TIPM programming. 1. Use a diagnostic scan tool to check and configure TIPM if required.
2. Automatic transmission in PARK position. 2. Place the transmission gear selector lever in any position except PARK.
3. Parking brake applied. 3. Release the parking brake.
4. Engine not running. 4. Start the engine.
5. Ineffective TIPM inputs or outputs. 5. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information.
scientia non olet · About LEMON Manuals