LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Lamps/Lighting - Exterior (Service Information)) >> Diagnosis And Testing >> Diagnosis And Testing - Lamps/Lighting - Exterior >> Backup Lamps

Backup Lamps

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
CONDITION POSSIBLE CAUSES CORRECTION
BACKUP LAMP DOES NOT ILLUMINATE 1. Ineffective or missing bulb. 1. Test and replace backup lamp bulb if required.
2. Ineffective ground circuit. 2. Test and repair open backup lamp ground circuit if required.
3. Ineffective feed circuit. 3. Test and repair open backup lamp feed circuit if required.
4. Ineffective switch. 4. Test and replace backup lamp switch (manual transmission) or transmission range sensor (automatic transmission) if required.
5. Ineffective TIPM inputs or outputs. 5. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information.
BACKUP LAMP DOES NOT EXTINGUISH 1. Ineffective feed circuit. 1. Test and repair shorted backup lamp feed circuit if required.
2. Ineffective switch. 2. Test and replace backup lamp switch (manual transmission) or transmission range sensor (automatic transmission) if required.
3. Ineffective TIPM inputs or outputs. 3. Use a diagnostic scan tool to test the TIPM inputs and outputs. Refer to the appropriate diagnostic information.
scientia non olet · About LEMON Manuals