LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Tires & Wheels (Service Information)) >> Wheels >> Stud, Wheel >> Removal >> Rear Wheel Stud

Rear Wheel Stud

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Do not use a hammer to remove wheel studs.

  1. Raise and support vehicle.
  2. Remove wheel and tire assembly.
    Fig 1: Stud
    GC0085489Courtesy of CHRYSLER GROUP, LLC
    1 - SPECIAL TOOL 8677
    2 - STUD
  3. Remove brake caliper and rotor. Refer to ROTOR, BRAKE, REMOVAL .
  4. Remove stud (2) from hub with Remover (special tool #8677, Remover, Ball Joint) (1).
    Fig 2: Removing/Installing Wheel Stud
    GC0085490Courtesy of CHRYSLER GROUP, LLC
    1 - STUD
    2 - PARK BRAKE SHOE
  5. Remove the stud (1) from between the hub/bearing and brake shoes (2)
scientia non olet · About LEMON Manuals