Rear Wheel Stud
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - STUD |
| 2 - PARK BRAKE SHOE |
- Install the new stud (1) into the hub flange by rotating the stud (1) in between the hub/bearing and park brake shoes (2).
- Install the three washers onto the stud, then install the lug nut with the flat side of the nut against the washers.
- Tighten the lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
- Remove the lug nut and washers.
- Install the brake rotor and caliper. Refer to CALIPER, DISC BRAKE, INSTALLATION .
- Install the wheel and tire assembly, use new lug nut on stud or studs that were replaced.
- Remove the support and lower vehicle.