Tire Pressure

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Check the tire pressure yellow telltale in the instrument cluster. If the yellow telltale is illuminating continuously, adjust the air pressure as necessary to that listed on the Tire Inflation Pressure Label (Placard) provided with the vehicle. After adjusting air pressure in a tire, allow approximately two minutes for the message or yellow telltale to go out. Inspect all the tires for leaks. A water "dunk tank" or other water test may be used as long as any water at the valve core is removed once the procedure is complete. The water can be easily expelled from the core area by pushing in on the core for several seconds, allowing escaping air to drive out any moisture. Reinflate the tire as necessary. Always make sure the original valve stem cap is securely installed to keep moisture out of the sensor. If the yellow telltale is still illuminating continuously or if the yellow telltale is flashing on/off for 60 seconds, once every ten minutes while drive, there is a system fault detected. Refer to TIRE PRESSURE MONITORING, DIAGNOSIS AND TESTING .