Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
VERIFY THE DTC IS ACTIVE
- Ignition on, engine not running.
- With the scan tool, read and record the DTCs.
- With the scan tool, erase the DTCs.
- Cycle the ignition from off to on.
- With the scan tool, read the DTCs.
Is the DTC Active at this time?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the NO RESPONSE FROM DTCM (DRIVETRAIN CONTROL MODULE) diagnostic procedure.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .