Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
INITIALIZE THE ABS MODULE
NOTE:
Diagnose and repair any Powertrain Module (PCM), VIN or Communication DTCs before continuing with this diagnostic procedure.
NOTE:
If C2202-00-Original VIN mismatch / Missing is set along with this DTC, perform the diagnostic procedure for C2202-00 before continuing with this test.
NOTE:
ABS initialization data will not be saved if ignition has not been off for five minutes or if battery has been disconnected.
- Perform any Technical Service Bulletins that may apply.
- With the scan tool, under "Miscellaneous Functions" perform the ABS Initialization routine.
- Turn ignition off to the lock position.
- Wait five minutes.
- Turn ignition on.
- With the scan tool, erase DTCs.
- With the scan tool, read DTCs.
Does the DTC remain active?
Yes
- Replace the Anti-lock Brake System (ABS) Module in accordance with the service information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time.