Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
NOTE:
This DTC must be active for the results of this test to be valid.
1. Perform any Technical Service Bulletins (TSBs) that may apply.
2. Ignition on, engine not running.
3. Using the scan tool, read and record DTCs.
4. Using the scan tool, read and record Environmental Data.
5. Using the scan tool, erase DTCs.
6. Start the engine.
7. Slowly turn the steering wheel from lock to lock.
8. Using the scan tool, read and record DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the ABS-INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .
CHECK FOR ANY ENGINE DTCs
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs in the PCM.
3. Cycle the ignition switch from off to on.
4. With the scan tool, read DTCs in the PCM.
  Are there any PCM DTCs?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to the DTC INDEX article .
  No
  - Using the schematics as a guide, check the Anti-lock Brake System (ABS) Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Anti-lock Brake Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .