Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY THE DTC IS ACTIVE NOTE:
This DTC must be active for the results of this test to be valid and this DTC may set while driving under severe load conditions.
- Turn the ignition on.
- With the scan tool, read and record DTCs.
- With the scan tool, read and record Freeze Frame information.
- With the scan tool, erase DTCs.
- Cycle the ignition switch from off to on.
- Start the engine and raise the engine RPM to 2500.
- With the scan tool, read and record DTCs.
Is the DTC active at this time?
Yes
- Go To 2
No
- Perform the ABS-INTERMITTENT CONDITION TEST. Refer to STANDARD PROCEDURE .
- CHECK ENGINE IDLE
- Allow the engine to idle.
Does the engine run rough at idle?
Yes
- Replace the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE for 2.4L gas engine or STANDARD PROCEDURE for 3.6L gas engine. .
No
- Replace the Anti-Lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- Allow the engine to idle.