Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- INCORRECT TIRES PROGRAMMED INTO BODY CONTROL MODULE
TIRE SIZE BODY STYLE ENGINE SIZE SALES CODE TIRE CIRCUMFERENCE P225/70R 16 ALL SEASON JC ALL TRD 2206 P225/65R 16 BSW TOURING JC ALL TRF 2220 P225/65R 16 BSW THREE SEASON JC ALL TUJ 2130 P225/65R 17 BSW A/S TOURING JC ALL TVK 2230 P225/55R 19 BSW THREE SEASON JC ALL TWC 2250 P225/55R 19 BSW AS TOURING JC ALL TMV 2270 - Inspect all four tires on the vehicle and note the size of each tire.NOTE:
A non-production size tire cannot be programmed into the BCM. The production Powertrain, with the production size tires, is the only emissions certified configuration that is available for reprogramming.
- Verify the correct Tire/wheel information is programmed in the BCM.
Is the correct value programmed in the BCM according to the chart?
Yes
- Go To 2
No
- Program the correct Tire/Wheel information in the BCM.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- Inspect all four tires on the vehicle and note the size of each tire.
- PERFORM THE ABS MODULE INITIALIZATION ROUTINE
- Turn the ignition on.
- With the scan tool, read and record the ABS DTCs.WARNING:
To avoid possible serious or fatal injury, check brake capability is available before road testing.
- Perform the ABS Module initialization, perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- Park the vehicle.
- With the scan tool, read the ABS DTCs.
Does the DTC remain active?
Yes
Perform the ABS Module Initialization routine again, if still unsuccessful.
Replace the Anti-Lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
Test complete.