Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
STEERING WHEEL POSITION SENSOR-INTERNAL ELECTRONIC FAILURE
- Perform any Technical Service Bulletins (TSBs) that may apply.
- The ABS Module is reporting internal errors from the SAS.NOTE:
Before continuing, check the Steering Angle Sensor harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
- Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
- Perform any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Replace the Steering Control Module (SCM) in accordance with the Service Information. Refer to MODULE, STEERING COLUMN, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .