Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

ANTI-LOCK BRAKE SYSTEM (ABS)

Perform any Technical Service Bulletins (TSBs) that may apply.
Turn the ignition off to the lock position.
Inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
Inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.
Were any problems found?

Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No

NOTE:
For this failure it is necessary to replace both the ABS Module and the HCU as a complete unit.
- Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Replace the Hydraulic Control Unit (HCU) in accordance with the Service Information. Refer to HYDRAULIC CONTROL UNIT (HCU), REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .