LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Installation >> Front Brake Hose

Front Brake Hose

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wheel Speed Sensor Wire, Brake Hose, Tube Nut & Bolt
GC0148409Courtesy of CHRYSLER GROUP, LLC
  1. Position the brake hose (4).
  2. Install the mounting bolt (2) for the brake hose to the frame routing clip and tighten to 20 N.m (177 in. lbs.).
  3. Install the brake line tube nut (1) to the brake hose (4) and tighten to 12 N.m (105 in. lbs.).
  4. Attach the wheel speed sensor wire (3) to the routing clip on the brake hose to frame routing clip.
    Fig 2: Wheel Speed Sensor Wire, Brake Hose, Clips, Bracket & Banjo Bolt
    GC0148408Courtesy of CHRYSLER GROUP, LLC
  5. Position the brake hose spring bracket (7), install the bolt (6) and tighten to 8 N.m (71 in. lbs.).
  6. Using two new copper washers, install the brake hose banjo bolt (4) at the caliper and tighten to 32 N.m (24 ft. lbs.).
    NOTE:

    All clips must be attached for proper routing.

  7. Attach the wheel speed sensor wire (2) to all brake hose clips (5).
  8. Attach the two wheel speed sensor push in type retainers (1) to the brake hose bracket (7).
  9. Remove the supports and lower the vehicle.
  10. Remove the prop rod from the vehicle.
  11. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed  . Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals