LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Pads And/Or Shoes, Brake >> Installation >> Rear Disc Brake Pads

Rear Disc Brake Pads

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Caliper Adapter, Mounting Bolts & Inboard/Outboard Brake Pad
GC0130657Courtesy of CHRYSLER GROUP, LLC
  1. Bottom pistons in caliper bore with C-clamp. Place an old brake shoe between a C-clamp and caliper piston.
  2. Clean caliper mounting adapter and anti-rattle springs.
  3. Install anti-rattle springs.
    NOTE:

    Anti-rattle springs are not interchangeable.

  4. Install inboard brake pad (3) in adapter (1).
  5. Install outboard brake pad (4) in adapter (1).
  6. Install caliper. Refer to CALIPER, DISC BRAKE, INSTALLATION .
  7. Install wheel and tire assemblies and lower vehicle. Refer to WHEELS, STANDARD PROCEDURE .
  8. Apply brakes several times to seat caliper pistons and brake pads to obtain firm pedal.
  9. Top off master cylinder fluid level.
scientia non olet · About LEMON Manuals