LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Caliper, Disc Brake >> Installation >> Front

Caliper, Disc Brake: Installation: Front

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Disc Brake Caliper & Components
GC0130323Courtesy of CHRYSLER GROUP, LLC
  1. Install the caliper (4) on the adapter.
  2. Caliper slide pins should be free from debris and lightly lubricated.
  3. Install the caliper slide pin bolts (3) and tighten to 35 N.m (26 ft. lbs.).
  4. Gently lift one end of the slide pin boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.
    CAUTION:

    Verify brake hose is not twisted or kinked before tightening banjo bolt.

  5. Install brake hose (1) to caliper (4) with new copper washers (6)  and tighten banjo bolt (6) to 31 N.m (23 ft. lbs.).
  6. Verify brake fluid level.
  7. Remove the prop rod from the brake pedal.
  8. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.  . Refer to STANDARD PROCEDURE  .
  9. Install wheel and tire assemblies.
  10. Remove supports and lower vehicle.
scientia non olet · About LEMON Manuals