Sway Bar Switch
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
The disconnecting stabilizer bar system will latch the momentary switch through software for an ignition switch OFF condition if the stabilizer bar was DISENGAGED and the transfer case was in 4LO at ignition switch OFF. Upon ignition switch RUN/START and the transfer case in 4LO, the system checks to verify all conditions to DISENGAGE the stabilizer bar are correct and then DISENGAGE the stabilizer bar without switch input.