Disconnecting Stabilizer Bar: Disengage
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
The bar will DISENGAGE when ALL the following conditions are met:
- vehicle speed under 18 MPH
- automatically at speeds over 14 MPH if the switch is in the ON position
- transfer case in 4 HI or 4 LO
- stabilizer bar switch message received for DISENGAGE
- ignition switch in the RUN or START position
- no stabilizer bar faults detected