Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FOR OBJECT HOLDING SWITCH IN AN ON POSITION
1. Inspect the A/C Heater Control for an object or debris holding the A/C On/Off Control Switch in an On position.
  NOTE:
  Using the scan tool you can read the On/Off status of the control switch.
  
  Is the A/C On/Off control switch being held in or stuck On?
  
  Yes
  - Clean or repair the A/C Heater Control as necessary. If you are unable to clean the switch to where the switch can work properly, replace and program the A/C Heater Control in accordance with the Service Information. Refer to CONTROL, A/C AND HEATER, REMOVAL .
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
A/C HEATER CONTROL
1. Turn the ignition on.
2. Using the scan tool, erase HVAC DTCs.
3. Turn the ignition off for 10 seconds, and then turn the ignition on and wait a minimum of 20 seconds.
4. Using the scan tool, read HVAC DTCs.
  Does the scan tool display this DTC as Active or is the status of the switch reading On?
  
  Yes
  - Replace and program the A/C Heater Control in accordance with the Service Information. Refer to CONTROL, A/C AND HEATER, REMOVAL .
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .