LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Cooling System) >> Accessory Drive >> Pulley, Idler >> Removal >> 2.8L

Pulley, Idler: Removal: 2.8L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drive Belt, Lifting Bracket, Idler Pulley & Bolt
GC0148194Courtesy of CHRYSLER GROUP, LLC
CAUTION:

The retaining bolts on the idler pulleys are left hand thread.

  1. Disconnect negative battery cable.
  2. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
  3. Remove bolt and the upper idler pulley (4).
  4. Remove bolt and the lower idler pulley (2).
scientia non olet · About LEMON Manuals