Belt, Serpentine: Removal: 2.8L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Lifting Bracket & Bolts

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Do not let the tensioner arm snapback to the fully extended position, severe damage may occur to the tensioner.

Disconnect the negative battery cable.
Remove the bolts (2) and the engine lifting bracket (1).

Fig 2: Removing/Installing Belt Tensioner Retaining Bolt And Tensioner
Courtesy of CHRYSLER GROUP, LLC
Using a suitable tool, rotate accessory drive belt tensioner (1) until holes on arm and base are aligned.
Insert pin (2) into hole to lock tensioner in place.
Remove the serpentine belt.