Belt, Serpentine: Installation: 2.8L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drive Belt Belt

Courtesy of CHRYSLER GROUP, LLC

1 - WITH A/C

2 - WITHOUT A/C

Check condition of all pulleys.
Install accessory drive belt. Route the belt around all pulleys (1 or 2).

Fig 2: Removing/Installing Belt Tensioner Retaining Bolt And Tensioner
Courtesy of CHRYSLER GROUP, LLC
Using a suitable tool, to hold accessory drive belt tensioner (1) and remove the pin (2).
Make sure the belt is seated onto all pulleys.
Slowly rotate and release the tensioner (1).

Fig 3: Engine Lifting Bracket & Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the engine lifting bracket (1). Tighten the bolts (2) to 69 N.m (51 ft. lbs.).
Connect the negative battery cable.