Rear Stabilizer Bar
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
| M10 Locations: |
| Stabilizer bar (5) |
| M12 Locations: |
| Fuel Tank Frame Rail (4) |
| Transmission Skid Plate (2) |
- Using a cut off wheel or equivalent, remove the rear stabilizer bolt with the damaged weld nut.
- Remove the damaged weld nut from the access hole in the in the frame rail (5).
- Position a new M10 type 2 nut into access hole in the frame rail and install the stabilizer bar bolt. Refer to STABILIZER BAR, REAR SUSPENSION, INSTALLATION .