LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Frame And Bumpers) >> Frame >> Standard Procedure >> Weld Nut Service >> Rear Bumper Bracket

Rear Bumper Bracket

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Bumper Bracket Components
GC0131107Courtesy of CHRYSLER GROUP, LLC
  1. Remove the rear bumper. Refer to BUMPER, REAR, REMOVAL .
  2. Using a cut off wheel or equivalent, remove the rear bumper support bracket bolt (4) with the damaged weld nut.
  3. Remove the damaged weld nut from the rear of the frame rail.
  4. Install a standard M10 nut into the end of the frame rail using a box end wrench and install the bracket bolt.
  5. Tighten the bolt to 55 N.m (40.5 ft. lbs.).
  6. Install the rear bumper. Refer to BUMPER, REAR, INSTALLATION .
scientia non olet · About LEMON Manuals