Second Row - Right
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- From the front of the second row right seat, engage the second row right buckle (2) through the elastic loop (3) of the right seat cushion trim cover and insert the buckle lower anchor between the right seat cushion and back trim covers.
- Reach under the rear edge of the second row right seat cushion frame just to the right of the lower end of the inboard center seat back hinge bracket (1) to position the buckle lower anchor (3) and the center seat belt lower anchor (2) to the right seat frame.
- Install and tighten the screw (4) that secures the buckle unit and the center seat belt lower anchor to the right seat frame. Tighten the screw to 39 N.m (29 ft. lbs.).
- Restore the second row right seat to the fully rearward position.