LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (NV241 Or Transfer Case (Service Information)) >> Removal >> Removal

Section 199 (NV241 Or Transfer Case (Service Information)): Removal: Removal

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
  2. Remove skid plate, if equipped. Refer to PLATE, SKID, FUEL TANK, REMOVAL ,PLATE, SKID, TRANSFER CASE, REMOVAL or PLATE, SKID, TRANSMISSION, REMOVAL .
  3. Position drain oil container under transfer case.
  4. Remove transfer case drain plug and drain lubricant into container.
  5. Disconnect vent hose and vacuum harness at transfer case switch.
  6. Disconnect shift rod from grommet in transfer case shift lever, or from floor shift arm whichever provides easy access. Use channel lock style pliers to press rod out of lever grommet.
  7. Support transmission with jack stand.
  8. Remove rear crossmember.
  9. Mark front and rear propeller shafts for assembly reference.
  10. Remove front and rear propeller shafts. Refer to SHAFT, DRIVE, FRONT, REMOVAL and SHAFT, DRIVE, REAR, REMOVAL .
  11. Support transfer case with suitable jack. Secure transfer case to jack with safety chains.
  12. Remove nuts attaching transfer case to transmission.
  13. Move transfer case assembly rearward until free of transmission output shaft.
  14. Lower jack and move transfer case from under vehicle.
scientia non olet · About LEMON Manuals