LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Steering System) >> Pump >> Removal >> 3.6L

Section 198 (Steering System): Pump: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Steering Pump Bracket, Bolt & Retainer
GC0153977Courtesy of CHRYSLER GROUP, LLC
  1. Remove the drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  2. Remove cap from power steering fluid reservoir.
  3. Siphon as much fluid as possible from the power steering fluid reservoir.
  4. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  5. Disconnect the wiring harness routing retainer (3) from the power steering pump bracket (1).
  6. Remove the lower power steering pump retaining bolt (2).
    Fig 2: Power Steering Return Hose, Supply Line, Retainer & Bolts
    GC0153979Courtesy of CHRYSLER GROUP, LLC
  7. Remove the supports and lower the vehicle.
  8. Remove the pressure hose (4) at the pump.
  9. Remove the supply hose (1) from the pump.
  10. Disconnect the wiring harness routing retainer (2) from the power steering pump bracket.
  11. Remove the upper power steering pump bracket retaining bolts (3).
  12. Remove the pump (with bracket).
    NOTE:

    The pump to bracket bolts are torqued to 24 N.m (18 ft. lbs.).

  13. Remove and transfer necessary components.
scientia non olet · About LEMON Manuals