LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Steering System) >> Pump >> Pulley, Power Steering Pump >> Installation >> Diesel

Pulley, Power Steering Pump: Installation: Diesel

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Steering Pump - 2.8L
GC0131164Courtesy of CHRYSLER GROUP, LLC
  1. Install the pulley (3) to the pump shaft.
  2. Install the three bolts (4) securing the pulley (3) to the pump (2). Tighten to 47 N.m (35 ft. lbs.).
    Fig 2: Turbo Air Inlet Tube
    GC0131163Courtesy of CHRYSLER GROUP, LLC
  3. Install the serpentine belt.
  4. Install the air inlet tube (1).
  5. Install the air cleaner box.
scientia non olet · About LEMON Manuals