Standard Procedure - Steering Linkage
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LHD shown in graphics. The removal and installation procedures and torques specs are the same for the RHD.
The tie rod end and ball stud seals should be inspected during all oil changes. If a seal is damaged, a complete replacement ball stud end should be installed.
CAUTION:
If any steering components are replaced or serviced an alignment must be performed, to ensure the vehicle meets all alignment specifications.