Tie Rod Tube

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Toe Link Tie Rod Adjustment

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle.
Remove the tire and wheel assembly.
Loosen the end clamp bolt (2).

Fig 2: Identifying Retaining Nuts
Courtesy of CHRYSLER GROUP, LLC
Remove the nut (3) at the steering knuckle.

Fig 3: Tie Rod End Separator
Courtesy of CHRYSLER GROUP, LLC
Separate the tie rod (3) from the knuckle (1) using special tool (special tool #9360, Remover, Ball Joint) separator (2).

Fig 4: Identifying Toe Link Tie Rod Adjustment
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Count the number of turns when removing the tie rod tube, This will give a good starting point when reassembling and toe adjustment.
Unthread the tie rod tube from the adjuster.