Tie Rod Tube

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views typical.

Fig 1: Identifying Toe Link Tie Rod Adjustment

Courtesy of CHRYSLER GROUP, LLC

Thread the tie rod tube onto the adjuster.
Insert the tie rod in the steering knuckle.
Install the tie rod ball stud nut (3) and tighten to 85 N.m (63 ft. lbs.).
Position the tie rod clamp (2) and tighten to 46 N.m (34 ft. lbs.).
Install the tire and wheel assembly.
Remove the supports and lower the vehicle.
Set the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .