Drag Link Tie Rod (Pitman Arm Side)
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Thread the tie rod end onto the drag link tube. Tighten the tie rod end adjustment sleeve bolt finger tight (1). Do not tighten to specs until after the toe set is complete.
- Install the tie rod end and nut to the pitman arm and tighten to 105 N.m (77 ft. lbs.).
- Lower the vehicle.
- Set the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .