LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Body - Interior & Exterior) >> Diagnosis And Testing >> Wind Noise >> Visual Inspection Before Tests >> Road Testing Wind Noise

Road Testing Wind Noise

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drive the vehicle to verify the general location of the wind noise.
  2. Apply 50 mm (2 in.) masking tape in 150 mm (6 in.) lengths along weatherstrips, weld seams or moldings. After each length is applied, drive the vehicle. If noise goes away after a piece of tape is applied, remove tape, locate, and repair defect.
scientia non olet · About LEMON Manuals