Repair Procedure For Door Fit And Primary Seal

This repair procedure is applicable when water is evident on the: 

Fig 1: Door Trim Panel & Instrument panel / A-pillar

Courtesy of CHRYSLER GROUP, LLC

• Door trim panel (1)
• Instrument panel / A-pillar (2)

Fig 2: Measure Door Gaps

Courtesy of CHRYSLER GROUP, LLC

1. Measure door gaps.

   The specifications are as follows:

   • The gap spec. is 5.0 +/- 2.0 mm
   • The flush spec. is 0.0 +/- 2.0 mm

   If the door fit is not to spec proceed to Step 2. If door is within specs proceed to step 3. 

   NOTE:

   When adjusting the door the seal must always be replaced

2. Adjust the door gap and flushness as described. Refer to ADJUSTMENTS  .
   Fig 3: Door Seal

   Courtesy of CHRYSLER GROUP, LLC
3. Inspect door seal (1) for folds and tears.
4. If the door was adjusted or flaws have been located in the seal, replace door seal (1).