LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Body - Interior & Exterior) >> Diagnosis And Testing >> Water Leaks >> Repair Procedure For A-Pillar MUCKET And Foam >> A-Pillar Foam

A-Pillar Foam

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bad (Missing Foam Seal)
GC0148354Courtesy of CHRYSLER GROUP, LLC
NOTE:

This issue/repair applies to both hard and soft top vehicles

  1. Inspect the freedom panel or side rail for damaged / missing foam.
  2. If the foam is damaged or missing (1), replace the foam using the foam kit available through Mopar Parts.
    Fig 2: Good Foam Seal
    GC0148360Courtesy of CHRYSLER GROUP, LLC

    The foam seal installed correctly, will appear as this - 

    Fig 3: Foam
    GC0148355Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Right side panel shown, Left side typical

    NOTE:

    The foam installation is similar for the soft top rail

  3. Install the foam (1) to the freedom panel as shown.