LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Wiper System & Washer System (Service Information)) >> Blade, Wiper >> Standard Procedure >> Standard Procedure - Rear Wiper Element Replacement

Standard Procedure - Rear Wiper Element Replacement

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Wiper Element Replacement
GC0127962Courtesy of CHRYSLER GROUP, LLC
  1. Remove the rear wiper blade (3) from the wiper arm. Refer to BLADE, WIPER, REMOVAL .
  2. Grasp one of the wiper blade links (4) firmly with one hand, and grasp the wiper element (1) and flexors (2) midway between the two links with the other hand.
  3. Pull the element and flexor away from the blade far enough to disengage them from the end pair of claws (5) of one link.
  4. Slide the element and flexor toward the loose end to disengage them from the remaining sets of claws.
  5. Reverse this process to install a new element and flexors into the wiper blade.
  6. Reinstall the wiper blade onto the wiper arm. Refer to BLADE, WIPER, INSTALLATION .
scientia non olet · About LEMON Manuals