Rear Center And Left - Four Door

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.

Fig 1: Identifying Second Row Center & Left Seat Belt Buckles (Four Door)

Courtesy of CHRYSLER GROUP, LLC

Fold the 60 percent second row seat back flat for easiest access to the center seat belt buckle (1) anchor, or the 40 percent seat back flat for easiest access to the left seat belt buckle (3) anchor.
Remove the nut (4) that secures the center or the left seat belt buckle anchor plate to the stud on the center seat bracket, hinge and latch unit (2).
Remove the buckle anchor plate from the stud.
Move the second row seat back to the uptight position.
Disengage the center or left second row seat belt buckle unit from the elastic loop integral to the seat cushion trim cover and remove the buckle from the vehicle.