Rear - Two Door

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.

Fig 1: Removing/Installing Second Row Seat Belt Buckles (2 Door)

Courtesy of CHRYSLER GROUP, LLC

Position the right and left seat belt buckle unit (2) anchor plate to the second row seat cushion frame (3).
Install and tighten the screw (1) that secures the anchor plate and buckle unit to the seat cushion frame. Tighten the screw to 55 N.m (41 ft. lbs.).