LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (Nag1 Automatic Transmission (Service Information)) >> Shifter, Transmission >> Installation >> Installation

Shifter, Transmission: Installation: Installation

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install shifter assembly onto the shifter assembly studs on the floor pan.
  2. Install the nuts to hold the shifter assembly onto the floor pan. Tighten nuts to 28 N.m (250 in. lbs.).
  3. Install wiring harness to the shifter assembly bracket. Engage any wire connectors removed from the shifter assembly.
  4. Install the park-interlock cable into the shifter assembly bracket and into the shifter lever.
  5. Install the shift cable to the shifter assembly bracket. Push cable into the bracket until secure.
  6. Place the floor shifter lever in park position.
  7. Loosen the adjustment screw on the shift cable.
  8. Snap the shift cable onto the shift lever pin.
  9. Verify that the shift lever is in the PARK position.
  10. Tighten the adjustment screw to 7 N.m (65 in. lbs.).
  11. Verify correct shifter operation.
  12. Verify proper BTSI operation. Refer to MECHANISM, BRAKE TRANSMISSION SHIFT INTERLOCK, DIAGNOSIS AND TESTING .
  13. Install any console parts removed for access to shift lever assembly and shift cables. Refer to CONSOLE, CENTER, INSTALLATION .
scientia non olet · About LEMON Manuals