LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (Nag1 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal >> Removal

Seal, Output Shaft: Removal: Removal

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the propeller shaft. Refer to SHAFT, DRIVE, FRONT, REMOVAL or SHAFT, DRIVE, REAR, REMOVAL . Move propeller shaft to the right and tie up.
  2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
    NOTE:

    When removing the propeller shaft flange be certain the shim remains on the output shaft.

  3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
  4. Remove the output shaft seal with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals