LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Antilock Brake System (Abs) (Service Information)) >> Hydraulic/Mechanical >> Integrated Control Unit (ICU) >> Removal >> Right-Hand-Drive

Integrated Control Unit (ICU): Removal: Right-Hand-Drive

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Before proceeding, refer to CAUTION and WARNING .

NOTE:

If servicing the ABM only, refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .

  1. Disconnect and isolate battery negative cable from battery post.
    Fig 1: Brake Pedal Holding Tool
    GC0098418Courtesy of CHRYSLER GROUP, LLC
  2. Using a brake pedal holding tool as shown in the illustration, depress the brake pedal past its first 25 mm (1 inch) of travel and hold it in this position. This will isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir while the lines are disconnected.
  3. Remove the engine appearance cover.
    Fig 2: Identifying Brake Tubes At Hydraulic Control Unit
    GC0079880Courtesy of CHRYSLER GROUP, LLC
  4. Remove the primary (4) and secondary (1) brake tubes (from master cylinder) at the Hydraulic Control Unit (HCU) (7).
  5. Remove the remaining brake tubes (2, 3, 5, 6) at the HCU (7).
    Fig 3: ABM Connector Release Tabs
    GC0079881Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Use this figure in the following step to release the Antilock Brake Module (ABM) harness connector cover. It shows the location of the release tabs.

    Fig 4: Anti-Lock Brake Module Wiring Harness Connector
    GC0081322Courtesy of CHRYSLER GROUP, LLC
    1 - ABM (PART OF ICU)
    2 - WIRING HARNESS CONNECTOR
  6. Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
    1. Depress the tabs on each side of the connector cover, then
    2. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be pulled straight outward off the ABM (1).
    Fig 5: Identifying ICU Mounting Components
    GC0098437Courtesy of CHRYSLER GROUP, LLC
  7. Loosen, but do not remove, the mounting nut (2) and screw (3) attaching the Integrated Control Unit (ICU) (1) mounting bracket to the body.
  8. Lift the ICU and mounting bracket (1) off the mounting stud and screw.
    NOTE:

    The HCU and the ABM are not serviceable separately from the ICU for vehicles equipped with Hill Start Assist (HSA).

  9. To separate the ABM from the HCU, refer to INTEGRATED CONTROL UNIT (ICU), DISASSEMBLY .
scientia non olet · About LEMON Manuals