LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Antilock Brake System (Abs) (Service Information)) >> Electrical >> Switch, Electronic Stability Program (Esp) >> Installation >> Installation

Switch, Electronic Stability Program (Esp): Installation: Installation

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The ESP Off switch is serviced as part of the accessory switch bank.

NOTE:

There are different instrument panel accessory switch banks available based on the option content of the vehicle. Ensure the accessory switch bank being installed matches the vehicle options.

  1. Position the accessory switch bank onto the back of the instrument panel center bezel.
  2. Install the screws that secure the accessory switch bank to the center bezel. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Install the center bezel onto the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
  4. Reconnect the negative battery cable.
  5. Perform the ABS Verification Test and make sure the ESP Off switch operates properly. Refer to STANDARD PROCEDURE .
  6. Verify proper operation of all components controlled by the switch bank.
scientia non olet · About LEMON Manuals